Replacement hull for Aerius Quattro 490. The hull top is made of pure, extremely tightly woven cotton, which is antifouling, high-pressure impregnated and especially breathable, with reinforced tips, four air sponsons, luggage spider in the back, carrying toggles in the front and back with return device, paddle pockets, lifeline and 25 cm keel strip.
Standard equipment:Lower hull: Black TPU Hull top colour: Red/BlackRear loading hatch is included with every Quattro modelFront loading hatch: NoFour air sponsonsLoad capacity: 360 kgDimensions: 490 x 72 cmEntry hatch: 135 x 41 cmDelivery: 1x replacement kayak hull for Aerius 490 Quattro - red/black - rear loading hatch
Bow fitting which is sewn into the front of the top. The boat line can be attached to it or a flagpole and pennant can be attached using an adapter.
Delivery: 1x bow fitting
Replacement carrying toggles for the kayak hull for comfortable carrying of the kayak..
Carrying toggle made of lacquered wood with corresponding line for knotting in the front or back of the kayak.
Colour: black
Delivery: 1x wooden carrying toggle
Replacement carrying toggles for the kayak hull for comfortable carrying of the kayak..
Carrying toggle made of lacquered wood with corresponding line for knotting in the front or back of the kayak.
Colour: nature
Delivery: 1x wooden carrying toggle
The D-rings are evenly distributed over the top hull. The life line is pulled through the D-rings and they also serve to tension the shrouds when sailing. In addition, the lifting line of the steering system can also be attached to the D-rings.
Inner width: 25 mmMaterial: plastic
Delivery: 1x D-ring for hull top - 25mm
The quick repair suitable for folding boat skins and air sponsons. The condition is that the hole is not larger than 90mm.The advantage of this mechanical patch is that two sealing lips fix and seal the material.How to get the hole tight again?Quite simple:1.examine the damaged area as far as possible and determine the shape and size of the crack. If the hole is smaller than 50mm, it must be widened to this size, otherwise one side of the clamp will not fit into the crack.2. Unscrew the clamp (red screw) and insert the side opposite the screw into the hole.3. pull the inner part on the cord tightly to the inside of the repair area. The longitudinal axis of the hole should coincide with the longitudinal axis of the clamp. 4.The thread now peeking out of the damaged area has two detents that must match the visible recesses of the outer part. Pull the cord and slide the outer part onto the thread and screw it in place. When the gray thread becomes visible on the red screw, the assembly is correct. 5. before you finally tighten the screw, you can correct the position of the clamp closure again. 6.finished! The hole is now secured with a temporary patch that can be used without time limit until the final repair is made.
KLEPPER repair kit for lower ship made of TPU in black.
Contents of delivery:1 repair piece for keel strip1 repair piece for the lower ship in black1 repair piece for the top in red1 air hose stopper1 repair piece air sponson1 roll fabric tape in black1 piece Sand paperPlease note: Adhesives are not included.
€50.00*
This website uses cookies to ensure the best experience possible. More information...